厂家供应一吨级压路机 小型压路机 微型压路机 迷你压路机

压路机操作安全知识
Roller Operation Safety Knowledge
压路机的运用操作的规划都是很安全的，但是一些需求的安全操作知识，大家要注意：
Roller operation planning is very safe, but some requirements of safe operation knowledge, we should pay attention to:
1，压路机操作人员在作业中不得擅离岗位，不得操作的不标准。禁止将机械设备交给未成年人员操作。禁止酒后操作;
1. Roller operators are not allowed to leave their posts without permission or to operate in a non-standard manner. It is forbidden to hand over mechanical equipment to minors for operation. No drunk operation;
2，每次作业前查看压路机润滑油、燃油和水是否足够，各种外表是否正常，传动体系、作业装配是否齐备，液压体系以及各管路等无泄露征象，承认正常后，方可发动;
2. Before each operation, check whether the lubricating oil, fuel and water of the roller are enough, whether the various appearances are normal, whether the transmission system and operation assembly are complete, whether the hydraulic system and the pipelines have no signs of leakage, and only after admitting that they are normal, can they be started.
3，操作人员有必要按照路友压路机的说明书规定，严格实行作业前的查看准则和作业中细致观察及作业后的查看保养准则;
3. It is necessary for operators to strictly implement the inspection criteria before operation, careful observation during operation and inspection and maintenance criteria after operation in accordance with the instructions of road companion roller.
4，压路机每次作业结束后，有必要洗掉其上的污物和尘埃，此时应特别注意柴油机、发电机、起动马达、喷油泵、喷油器、液压泵等，以及液压管路的外表的清洁，有必要用干燥柔软的抹布把这些当地擦洁净。,5，压路机如果停放较长时刻，有必要放出发动机水箱内的水，（在冬天气候冰冷，每天作业结束后就应放掉）。细心清洗掉机器上的污物和尘埃，用火油擦洗各部件的外外表和全部光滑孔并注一次油脂，对未涂漆的外露部分应涂黄油或防锈胶。
4. It is necessary to wash away the dirt and dust on the roller after each operation. At this time, special attention should be paid to the cleanliness of diesel engine, generator, starting motor, fuel injection pump, injector, hydraulic pump, and the appearance of hydraulic pipeline. It is necessary to clean these areas with dry and soft cloth. 5. If the roller is parked for a long time, it is necessary to release the water in the engine water tank. (In winter, when the weather is cold, it should be released after every day's operation.) Carefully clean the dirt and dust on the machine, scrub the appearance and all smooth holes of each component with fire oil and inject grease once. Butter or anti-rust glue should be applied to the uncoated exposed part.
PS：产品所有价格均为网上报价，请以实物为准，
?具体价格请来电详询！！！
温馨提示：我工厂所有设备发货方式均为货运物流，运费由地方远近和货物方数决定，具体运费请来电详询，以便造成不必要的误会！